Need help?Do you have a question about the Commend GE 300 and is the answer not in the manual?
General| Brand | Commend |
|---|---|
| Model | GE 300 |
| Category | Intercom System |
| Language | English |
Introduction to the GE 300/GE 300WR Intercom Server and its capabilities.
Outlines the sequence of steps required for the initial start-up of the GE 300 system.
Lists and describes various components required for system setup, including cards and licenses.
Details the slots available for different card types in GE 300, GEZ 300, and GEI 300.
Provides a diagram and dimensions for mounting and routing cables for GE 300, GEZ 300, GEI 300.
Details how to mount the GE 300 with a cover for protection against contact, according to IEC/EN 60950-1.
Illustrates the wiring connections for GE 300, GE 300WR, GEZ 300, and GEI 300 components.
Shows how to connect the GE 300 Intercom Server to a network or switch via the Uplink socket.
Explains how digital, analogue, and IP subscribers connect to the Intercom Server.
Explains how to configure the GE 300 Intercom Servers using RS-232 or standard network cable.
Details the process of connecting and configuring the Intercom Server via IP/Ethernet.
Instructions for starting up a networked system, including setting server IDs with DIP switches.
Step-by-step guide on using DIP switches to set server IDs for networked housings.
Guides on how to set the server ID for a new Intercom Server using the CCT 800 software.
Instructions on how to change the server ID of an existing Intercom Server using CCT 800.
Covers auto-configuration, CCT 800 settings, and additional network options for the Intercom Server.
Details how to configure IP address, subnet mask, and Ethernet modes using CCT 800.
To Next Page
