Commend GE 300 - IP-Network Card G3-LAN LED Status

GE 300 LED-status indication
3.3/0518 31
IP-network card G3-LAN
Network card to connect the Intercom Server GE 300 via Ethernet.
Network card G3-LAN
LED status indication “RUN”
LED status indication “LAN”
LED-status Description
LED is blinking in a one
second rhythm
The card is working correctly
LED is permanently off No power, warm start or hardware fault
LED is permanently on Waiting for connection to the main processor (during initialisation)
LED is blinking fast Card in the wrong slot or during firmware download
LED is blinking in
rhythm definition error
“short - short - long“
Card with wrong hardware feature level inserted (e. g. card “G3-IP-4B” inserted in slot
which is configured for “G3-IP4C”)
NOTE: Only LED “S1” is controlled
On the card G3-LAN, only the status LED “S1” is controlled.
LED-status Description
LED is permanently off No connection to the network
LED is permanently on
Connection to the network and to all defined Servers is correct (or no Intercom Servers
are defined)
LED is blinking
Data fault. The time interval of one second is separated in consistent blocks for the
connection to the network and all defined Intercom Servers
Example: One Intercom Server; it can not be rea-
ched:
Example: Three Intercom Servers; the as the first
one defined server can not be reached. :
RUN LAN
LED on
Network
LED of
f
1 sec 2 sec
1st Server
Network
1st
Server
LED on
LED of
f
1 sec 2 sec
Network
1st Server
2nd Server
3rd Server
Network
1st Server
2nd Server
3rd Server