Commodore MPS-801 - MAINTENANCE

7. MAINTENANCE
We hope you don't have problems but just in case ... see if you can solve
them by using the table below.
If you can't, then try to determine which
component
in your system is at fault, and bring it into a store for repair.
Problems
Printer won't print.
Power Indicator
'OFF'.
Probable Causes/Solutions
1) Printer power is 'OFF'.
Check the connection and the power
switch.
2) Fuse may
be blown.
Replace only with a fuse
of the same
---------------------------------------------------!..~-~~~-~:--------------.-------------.----.---.------------------
Printer won't print.
Power Indicator 'ON'.
I) Improper connection.
Check all the cable connection~.
2) Improper ribbon setting.
-----.-----.-.- .. ----.-.-------.---.------.-.- ... ---~~:.'~~~~~~.-.-~~~ .. :~~~~~:-.- .. -- ... -.-.-- ..... -... -.....
Printer okay, but the paper Paper is jammed.
won't advance. Remove and reload the paper.
-_ ........... -_ ............................................ ----- .. - ....... - ............................................... _---- ...... _- ........ --- .. -------------------- .. _-_ .... ----- ....... -
Printed characters are too
light or smudging.
1) Improper printing pressure.
Adjust the lever's position on the left
inside.
2) Wrong ribbon setting.
Re-adjust the ribbon
3) Old or worn-out ribbon.
Replace the ribbon.
15.