8.
CAUTIONS
• Wait at least two seconds to turn on the
power
after it
is
turned
off,
otherwise
the
Printer will
not
be initialized
properly.
• Never place the Printer where it
is
exposed
to
direct
sunlight.
• Never apply power while
you
are plugging in
or
unplugging an
input
connector.
Never turn
off
the power while the Printer
is
in
motion.
• Never try
to
move the print
head
manually,
whether
the
power
is
on
or off.
• Do
not
stop the print head
motion
while it
is
printing.
• Do
not
print without paper
and/or
ribbon because the
print
head
might
be
damaged.
• Turn
off
the power quickly
and
remove a foreign object, if
you
drop
it
into
the Printer.
•
Do
not
subject the Printer to temperatures below
SoC
or
above 40·C
during operations, or to a sudden change in
temperature.
Regarding printing
duty:
In graphic mode, using patterns with
too
much
dot
density will wear
out
the print head faster.
We
recommend
that
you
use
patterns
whose dot density
is
equal
to
that
of
ordinary
alphanumerics. The
continuous printing
of
high
dot
density
patterns
may adversely
affect the longevity
of
the
print head.
• Unplug the power cord before trying
to
take
off
the
outer
casing.
16.
To Next Page
Loading...
