3. Safety regulations
3-1
3.1 Identification Of Safety
Guidelines
3.2 General Safety Instructions
MAKO is not liable for any damage or injury
resulting from the non-observance of these
safety instructions or negligence of the usual
care and attention required during
installation, handling, operation,
maintenance or repair, even if this is not
explicitly mentioned in these operating
instructions.
If any of the regulations contained in these
instructions - especially with regard to safety
- does not correspond to the local legal
provisions, the stricter of both shall prevail.
Passages marked with this designation
indicate a possible danger to personnel.
Passages marked with this designation
indicate possible damage to unit.
Passages marked with this designation
provide technical or procedural information
for the optimal cost-effective use of the unit.
The operating instructions must always be at
hand at the place of operation of the unit!
In addition to the operating instructions, all
other generally applicable legal and other
mandatory regulations relevant to accident
prevention and environmental protection
must be adhered to and passed on to others!
These compulsory regulations may also deal
with the handling of hazardous materials or
the issuing/wearing of personal protective
equipment, or traffic regulations.
Organizational Measures
Danger!
Important!
Note.
Instructions, including supervisory
responsibility and duty of notification for
taking into account in-plant factors, for
example regarding work organization,
sequences of operations, personnel assigned
to certain tasks, are to be kept with the
operating manual.
The personnel entrusted with the operation
and/or maintenance of the unit must have
read the operating instructions and in
particular the chapter on safety regulations
before starting work. Reading the instructions
after work has begun is too late. This applies
especially to persons working only
occasionally on the machine, e.g. for setting
up or maintenance.
supervisors should check on a regular basis
that the personnel are carrying out the work
in compliance with the operating instructions
and that they are paying attention to the
safety requirements!
Observe all safety and warning notices
attached to the unit!
See to it that safety instructions and warnings
attached to the machine are always complete
and perfectly legible.
In the case of safety-relevant changes to the
unit or its operating behavior, stop the unit
immediately and report the fault to the
responsible department or person!
Spare parts have to comply with the technical
requirements specified by the manufacturer.
This can always be ensured by using only
genuine MAKO spare parts.
High pressure hoses have to be changed
within stipulated and periodic intervals, even
if no safety-relevant faults have been
detected.
Adhere to prescribed intervals or those
specified in the operating instructions for
routine checks and inspections!
To Next Page
Loading...
Need help?
General