8-3
8. Troubleshooting
8.4.4 Time Menu
This menu will coordinate the date and time of
the CMM unit with real-time. This is
important to set correctly for the CO
calibration period to function as expected.
The date/time should be entered by the
factory, however, it should also be checked at
start-up.
To enter/check the date/time press 4 at the
factory menu.
0904060410
format: YYMMDDHHMM
fig 8.4.4-1
Enter the date/time information in the format
shown on the screen.
This menu stores the serial number of the
CMM board and should not be changed.
8.4.5 Serial # Menu
SERIAL: 1032
NEW:
fig 8.4.5-1
Ensure the serial number matches the
number on the rear of the CMM.
To Next Page
Loading...