1. Remove the keyboard (Section 5.5).
2. Remove the front bezel (Section 5.14).
3. Remove the display assembly (Section 5.14).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
WARNING
The display inverter board contains high voltage. Avoid contact with all
surfaces of the board.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
CAUTION
When removing or inserting cables with ZIF connectors, do not pull, twist, or
apply tension to cables.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
NOTE: The ZIF connectors in this product have mechanical latches that either
slide forward and lift up or slide up to open. Be sure the latches on the
ZIF connectors are opened before attempting to remove the cable.
4. Carefully disconnect the power distribution board cable from the ZIF
connector on the display inverter board (Figure 5-23).
5. Carefully disconnect two cables from the display assembly (Figure 5-23).
To Next Page
Loading...
Need help?
General