IMPORTANT: When replacing the system board, the screws must be replaced as
follows:
1. Install screws [1] and [2] on the system board before replacing the
remaining system board and battery contact screws (Figure 5-52).
PC Card (PCMCIA) Assembly
The PC Card assembly consists of the PC Card clip and PC Card rails. To
remove the PC Card assembly or to remove part of the assembly, follow the
steps below.
Removing the PC Card Clip
To remove the PC Card clip, follow these steps:
1. Turn the computer off and remove all external devices, including the
battery pack and the AC Adapter. Remove the diskette and PC Card, if
installed (Section 5.3).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The computer becomes top-heavy when the keyboard assembly is removed and
the display is opened. To prevent damage to the display and the computer,
ensure that the display assembly is opened at a 90-degree angle.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To Next Page
Loading...
