o Conductive table-top workstations with ground cord of 1 megohm of
resistance
o Static dissipative table or floor mats with hard tie to ground
o Field service kits
o Static awareness labels
o Wrist straps and footwear straps providing 1 megohm +/- 10% resistance
o Material handling packages
o Conductive plastic bags
o Conductive plastic tubes
o Conductive tote boxes
o Metal tote boxes
o Opaque shielding bags
o Transparent metallized shielding bags
o Transparent shielding tubes
Service Considerations
Listed below are some of the considerations that should be kept in mind
during the disassembly and assembly of the computer.
Tool Requirements
o Torx T-8 screwdriver
o Flat-bladed screwdriver
o Tool kit, Compaq part number 100767-001 (includes case utility tool,
connector removal tool, and loopback plugs)
o 3/16-inch hex socket wrench
o Preloaded application diskettes (Compaq Order Center, 1-800-952-7689)
Cables and Connectors
Apply only the tension required to seat or unseat the cables during
insertion or removal from connectors. Handle cables by the connector or
pull tabs whenever possible. In all cases, avoid bending, twisting, or
tearing the cables, and ensure that cables are placed in such a way that
they cannot be caught or snagged by parts being removed or replaced.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
When servicing these computers, ensure that cables are placed in their
proper location during the reassembly process. Improper cable placement
can cause severe damage to the unit.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Serial Number
The computer serial numbers should be provided to Compaq whenever
requesting information or ordering spare parts. The serial number is
located on the bottom of the CPU next to the memory compartment cover.
To Next Page
Loading...
Need help?
General