.
.
screws to secure the diskette drive to the bracket.
NOTE: When replacing the diskette drive into the bracket, secure the front
two screws first.
2. Toe in the back end of the diskette drive into the system chassis.
IMPORTANT: Ensure that the diskette drive door does not catch on the
outside edge of the system unit module.
3. Close the diskette drive door slightly while lowering the front of the
diskette drive into the system chassis (Figure 5-42).
4. Reconnect the diskette drive cable and reinstall the five screws.
IMPORTANT: The screw order for the five screws is important. The three
screws that connect the diskette drive bracket to the system
board have a tighter tolerance than the two screws that connect
the bracket to the heatspreader; therefore, you must install the
three screws to the system board before you install the two
screws to the heatspreader.
The System Board
To remove the system board, follow these steps:
1. Turn the computer off and remove all external devices, including the
battery pack and the AC Adapter Remove the diskette and PC Card if
.
,
1 Replace the diskette drive into the diskette drive bracket Use the four
To Next Page
Loading...
Need help?
General