10. Carefully insert the end of the display ground cable into the ZIF
connector slide on the system board.
IMPORTANT: Ensure that the ZIF connector slide is in its fully upward
position and that it remains so while you are inserting the
cable into it. Before closing the slide, ensure that the cable
is fully seated (to the white insertion line) in the ZIF
connector.
11. While holding the end of the display cable inside the ZIF connector
slide, press down both ends of the slide simultaneously to secure the
cable in the ZIF connector (Figure 5-97).
12. Ensure that the cable has been seated evenly and that the white line
on the cable is level.
13. Replace the keyboard assembly (Section 5.7).
Color TFT (10.4 in) Display
This section contains removal and replacement procedures for the following
CTFT (10.4 in) display components:
To Next Page
Loading...
