Compaq Armada 1500 - Audio Board, Speakers, and Audio Cable

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Computer Removal and Replacement Procedures 7-41
7.15 Audio Board, Speakers, and Audio
Cable
CAUTION: The Audio board is secured by a short, T-8 screw. Do not use the long, T-8
screw to secure the Audio board. Use of the long screw may damage the system board.
To remove the audio board, speakers, and audio cable, complete the following
procedures:
1. Disconnect the AC power and any external devices (Section 7.4.1).
2. Remove the battery pack (Section 7.4.3).
3. Remove the DualBay device (Section 7.4.4).
4. Remove any PC Cards (Section 7.4.5).
5. Remove the keyboard (Section 7.7).
6. Remove the microphone/display cable cover and microphone (Section 7.11).
7. Remove the clutch covers/display assembly (Section 7.12.1).
8. Remove the LED status panel board (Section 7.14).
9. Remove the screw from the audio board.
Figure 7-37. Removing the Screw from the Audio Board