Compaq Armada 1500 - External Computer Components; Computer Logo; Computer Feet

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7-54 Computer Removal and Replacement Procedures
7.21 External Computer
Components
This section describes the removal and replacement procedures that do not require
access to the internal components of the computer. This includes:
n Computer logo
n Computer feet
7.21.1 Computer Logo
The computer logo is on the outside of the display assembly and may be replaced if
damaged. To replace the logo, complete the following steps:
1. Use a small, sharp, flat-bladed screwdriver to pry up the existing logo.
2. Clean the area with a clean dry cloth.
3. Apply the new logo.
7.21.2 Computer Feet
There are four locations where the computer feet may be applied. To replace the
computer feet, complete the following steps:
1. Peel the old foot from the computer. Use a razor blade if needed to lift a corner of the
foot free from the base cover.
2. Clean the area where the new foot is to be applied with a clean dry cloth.
3. Install the new foot, pressing it firmly into place.