. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Computer Removal and Replacement Procedures 7-9
7.4.5 PCMCIA
Remove any installed PC (PCMCIA) Cards before performing any service on the
computer. To remove a PC Card, complete the following steps:
1. Rotate the PC Card eject lever to the forward position
1
.
2. Press the PC Card eject button
2
.
3. Pull the PC Card out of the PC Card slot
3
.
Figure 7-5. Removing the PC Card
To install a PC Card, insert the card into the slot and press firmly until it is seated.
NOTE: Before replacing the system board, the PC Card eject levers must be in the
forward position. See Section 7.18 on removing the system board.
To Next Page
Loading...
