Compaq CONTURA AERO - Page 103

2. Check and/or replace the diskette
602 - xx Diskette read test power and signal cables and
failed PCMCIA external diskette drive.
3. Replace the diskette drive and
603 - xx Diskette write, read, retest.
compare test failed 4. Replace the system board and
retest.
604 - xx Diskette random seek
test failed
605 - xx Diskette ID media
failed
606 - xx Diskette speed test
failed
607 - xx Diskette wrap test
failed
608 - xx Diskette write protect
test failed
609 - xx Diskette reset
controller test failed
610 - xx Diskette change line
test failed
697 - xx Diskette type error
698 - xx Diskette drive speed
not within limits
---------------------------------------------------------------------------
699 - xx Diskette drive/media 1. Replace diskette.
ID error 2. Run Computer Setup.
===========================================================================
Table 5-7. Serial Test Error Codes
===========================================================================
Error Code Description Recommended Action
===========================================================================
1101 - xx Serial Port test The following steps apply to
1101 - xx through 1109 - xx error
1109 - xx Clock Register test codes:
Replace the system board and retest.
===========================================================================
Table 5-8. PCMCIA Modem Test Error Codes
===========================================================================
Error Code Description Recommended Action
===========================================================================
1201 - xx Modem Internal The following steps apply to
Loopback Test 1201 - xx through 1210 - xx error
codes:
1202 - xx Modem Time Out Test
1. Refer to modem documentation for
1203 - xx Modem External correct Computer Setup
Termination Test procedures.
2. Check the modem line.