2. Try another AC Adapter.
3. Check the battery slot and make sure it is clear.
If the mouse or keyboard does not work, check to make sure they are plugged
into the correct jack.
If the printer or serial ports do not work, follow these steps:
1. Disconnect the computer from the base unit.
2. Connect the cables to the printer and serial ports of the computer.
3. If the ports work on the computer, the base unit is defective.
Replacing the Tilt Feet
To replace the tilt feet on the base unit, follow these steps:
1. Remove the computer from the base unit.
2. Turn the base unit upside down.
3. Open up the foot and remove the screw that secures the foot to the base.
4. Pull out the foot, then press in a new one.
5. Replace the screw.
To Next Page
Loading...
