Chapter 5. Error Messages and Codes
Chapter 5.0 Introduction
This chapter contains Power On Self Test (POST) messages, Diagnostic error
codes, and memory error codes.
The messages and codes appear in tables that include a description of the
error, the probable cause, and the recommended action that should be taken
to resolve the error condition.
Chapter 5.1 Power On Self Test Messages
An error message results if a problem is encountered from the Power On Self
Test utility. This utility runs automatically when the system is turned
on.
Table 5-1 lists the messages for POST, the audible (beep) message, probable
cause, and recommended action.
Table 5-1. Power On Self Test Messages
===========================================================================
Message: 101 ROM Error
Beeps: 1 Long, 1 Short (Beeps can be disabled by the user from
the Computer Setup utility.
Probable Cause: ROM checksum option
Recommended Action: 1. Verify the correct ROM.
2. Replace the system board.
---------------------------------------------------------------------------
Message: 101 ROM Error
Beeps: 1 Long, 1 Short (Beeps can be disabled by the user from
the Computer Setup utility.
Probable Cause: System ROM
Recommended Action: 1. Verify the correct ROM.
2. Replace the system board.
---------------------------------------------------------------------------
Message: 101 ROM Error
Beeps: 1 Long, 1 Short (Beeps can be disabled by the user from
the Computer Setup utility.
Probable Cause: VDU ROM checksum error
Recommended Action: 1. Verify the correct ROM.
2. Replace the system board.
---------------------------------------------------------------------------
Message: 101 ROM Error
Beeps: 1 Long, 1 Short (Beeps can be disabled by the user from
the Computer Setup utility.
To Next Page
Loading...
Need help?
General