Technical Reference Guide
Compaq Personal Computers
Changed – November 2000
A-11
A.19 SCSI INTERFACE ERROR MESSAGES (65xx-xx, 66xx-xx, 67xx-xx)
Table A–18. SCSI Interface Error Messages
Table A-18.
            SCSI Interface Error Messages
Message Probable Cause Message  Probable Cause 
6nyy-02  Drive not installed  6nyy-33  Illegal controller command 
6nyy-03  Media not installed  6nyy-34  Invalid SCSI bus phase 
6nyy-05  Seek failure  6nyy-35  Invalid SCSI bus phase 
6nyy-06  Drive timed out  6nyy-36  Invalid SCSI bus phase 
6nyy-07  Drive busy  6nyy-39  Error status from drive 
6nyy-08  Drive already reserved  6nyy-40  Drive timed out 
6nyy-09  Reserved  6nyy-41  SSI bus stayed busy 
6nyy-10 Reserved  6nyy-42  ACK/REQ lines bad 
6nyy-11  Media soft error  6nyy-43  ACK did not deassert 
6nyy-12  Drive not ready  6nyy-44  Parity error 
6nyy-13  Media error  6nyy-50  Data pins bad 
6nyy-14  Drive hardware error  6nyy-51  Data line 7 bad 
6nyy-15  Illegal drive command  6nyy-52  MSG, C/D, or I/O lines bad 
6nyy-16  Media was changed  6nyy-53  BSY never went busy 
6nyy-17  Tape write-protected  6nyy-54  BSY stayed busy 
6nyy-18  No data detected  6nyy-60  Controller CONFIG-1 register fault 
6nyy-21  Drive command aborted  6nyy-61  Controller CONFIG-2 register fault 
6nyy-24  Media hard error  6nyy-65  Media not unloaded 
6nyy-25 Reserved  6nyy-90  Fan failure 
6nyy-30  Controller timed out  6nyy-91  Over temperature condition 
6nyy-31  Unrecoverable error  6nyy-92  Side panel not installed 
6nyy-32  Controller/drive not connected  6nyy-99  Autoloader reported tape not loaded properly 
n = 5, Hard drive      yy = 00, ID 
   = 6, CD-ROM drive         = 03, Power check 
   = 7, Tape drive.         = 05, Read 
             = 06, SA/Media 
           = 08, Controller 
           = 23, Random read 
           = 28, Media load/unload 
 
 
A.20 POINTING DEVICE INTERFACE ERROR MESSAGES (8601-xx)
Table A–19. Pointing Device Interface Error Messages
Table A-19.
            Pointing Device Interface Error Messages
Message Probable Cause Message  Probable Cause 
8601-01  Mouse ID fails  8601-07  Right block not selected 
8601-02  Left mouse button is inoperative  8601-08  Timeout occurred 
8601-03  Left mouse button is stuck closed  8601-09  Mouse loopback test failed 
8601-04  Right mouse button is inoperative  8601-10  Pointing device is inoperative 
8601-05  Right mouse button is stuck closed  8602-xx  I/F test failed 
8601-06  Left block not selected  --  --