Compaq Deskpro Workstation AP230 - Board Layouts; Figure 2-7. Small Form Factor

Chapter 2 System Overview
Compaq Deskpro Personal Computers
Third Edition – April 2001
2-10
2.3.3 BOARD LAYOUTS
Item Description Item Description
1 SCSI hard drive LED connector 19 Power supply connector
2 PCI bus expansion connectors 20 Secondary IDE connector
3 AOL/SOS connector 21 Primary IDE connector
4 Riser card connector 22 Diskette drive connector
5 PS/2 mouse connector 23 CD-ROM audio connector (right angle)
6 PS/2 keyboard connector 24 CD-ROM audio connector (vertical)
7 Monitor connector 25 Headphone output jack [3]
8 Top: USB port B; Bottom: USB port A 26 Microphone input jack [3]
9 Serial port COM2 connector 27 PCB speaker [4]
10 Network interface connector 28 CMOS battery
11 Parallel port LPT1 connector 29 Processor socket
12 Audio line in jack [3] 30 Hard drive activity LED
13 Audio line out jack [3] 31 Power button
14 Serial port COM1 header [1] 32 Power LED
15 Smart Cover Lock solenoid connector 33 DIMM sockets
16 Firmware Hub (BIOS ROM) 34 CMOS memory clear button
17 Password jumper [2] 35 Smart Cover Sensor switch
18 Speaker connector [3] -- --
NOTES:
NVIDIA graphics components installed on PCA# 010633 only.
[1] Header connects to COM1 DB-9 connector on I/O panel via cable assembly.
[2] Jumper installed, password enabled. Jumper removed, password is cleared.
[3] Not installed on PCA# 011035.
[4] Installed on PCA# 011035 only.
Figure 2–7. Small Form Factor Board Layouts
3334
32
32
8 11
12
14
10
18
9
20
6 7
13
17
15
16
19
28
21
30
22
29 26
23
24
5
2423 31
2 41
35
S
y
stem Board PCA# 010633
,
010700
,
or 011035
Riser Board PCA# 010636
25
27