USB Legacy Mode
Support
Allows you to set:
●
Disabled
●
Enabled
Onboard LAN Allows you to disable/enable onboard LAN controller.
Onboard LAN Boot
ROM
Allows you to disable/enable the boot ROM of the onboard LAN chip.
SATA1 Controller Allows you to disable/enable the SATA1 Controller.
SATA1 Controller
Mode
If SATA1 Controller is enabled, allows you to set the mode to:
●
IDE
●
AHCI
SATA2 Controller Allows you to disable/enable the SATA2 Controller.
Onboard Audio Allows you to set the onboard audio to:
●
Auto
●
Disabled
●
Enabled
Internal Speaker Allows you to set the internal speaker to:
●
Disabled
●
Enabled
Supervisor Password Allows you to change supervisor password.
User Password Allows you to change the user password.
Computer Setup—Power
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 2-3 Computer Setup—Power
Option Description
After AC Power Failure Allows you to select system restart behavior after power loss:
●
Stay Off
●
Power On
●
Auto
XD Disables/enables XD (eXecute Disable) bit.
NOTE: The XD bit is a technology used in to separate areas of memory for use by either storage
of processor instructions or code or for storage of data. Memory designated with the NX attribute
may only be used for storing data. Processor instructions should not reside and cannot be executed
there. This technology is used to prevent buffer overflow attacks – malicious software that takes over
computers by inserting code into another program's data storage area and running that code.
Table 2-2 Computer Setup—Advanced (continued)
6 Chapter 2 Computer Setup (F10) Utility
To Next Page
Loading...
Need help?
General