9. Connect the power cable (1) and data cable (2) to the rear of the optical drive.
10. Replace the front bezel and access panel.
11. Lock any security devices that were disengaged when the access panel was removed.
The system automatically recognizes the drive and re-configures the computer.
Removing an External 3.5-inch Drive
CAUTION: All removable media should be taken out of a drive before removing the drive from the
computer.
NOTE: The 3.5-inch drive bay may contain a diskette drive or a media card reader.
1. Prepare the computer for disassembly (Preparation for Disassembly on page 26).
2. Remove the computer access panel (
Computer Access Panel on page 30).
3. Remove the front bezel (
Front Bezel on page 31).
48 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
To Next Page
Loading...
