USB device does not work with the
system.
The USB
device and
the system
may use
different USB
architectures.
Ensure that the USB device and the system
have the same USB architecture.
(UHCI-compliant devices only work with an
UHCI-compliant system, and OHCI-compliant
devices will only work with a OHCI-compliant
system.)
Return to top
Disk Drive
Problem Probable Cause(s) Possible Solution
Disk drive light stays on.
Disk may be damaged. Remove disk, insert new disk into
disk drive.
Disk may be installed incorrectly Remove disk, reinsert into disk
drive.
Software program may be
damaged.
Check the program disks.
Disk drive cannot write to a
disk.
Disk is not formatted. Format disk.
Important: Formatting removes
all saved information from the
disk.
Disk is write-protected. Either use another disk that is not
write-protected or move the
write-protect tab on the disk to
the unprotected position.
Writing to the wrong drive. Check the drive letter in your
path statement.
Not enough space is left on the
disk.
Remove disk, insert new disk into
disk drive.
Disk drive cannot read a disk.
Disk is not formatted. Format disk.
Using the wrong disk type for the
drive type.
Use a disk that is compatible with
the drive.
Reading the wrong drive. Check the drive letter in your
path statement.
Disk drive has been disabled by
Computer Setup.
Run Computer Setup and enable
the disk drive.
Return to top
To Next Page
Loading...
