EasyManua.ls Logo

Compaq Presario 5000 Series - Power Cord Set Requirements

Compaq Presario 5000 Series
217 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
United States
STORE | PRODUCTS | SERVICES | SUPPORT | CONTACT US | SEARCH
Compaq Presario Internet PC 5000 Series Computers
Product Description
PRODUCT DESCRIPTION
TROUBLESHOOTING ILLUSTRATED PARTS CATALOG
REMOVAL AND REPLACEMENT
PROCEDURES
JUMPER AND SWITCH
INFORMATION
SPECIFICATIONS
Models and
Features
CPU Controls
and Lights
Side Access
Panel
Internet
Keyboard
Controls
Rear CPU
Connectors
Power Cord Set
Requirements
Power Cord Set Requirements
Requirements
The power cord set (flexible cord and wall plug) received with the computer meets the
requirements for use in the country where the computer was purchased.
Power cord sets for use in other countries must meet the requirements of the country
where you use the computer. For more information on power cord set requirements,
contact your Compaq authorized dealer, reseller, or service provider.
General Requirements
The requirements listed below are applicable to all countries:
The length of the power cord set must be at least 6.00 feet (1.8 m) and a
maximum of 9.75 feet (3.0 m).
1.
All power cord sets must be approved by an acceptable accredited agency
responsible for evaluation in the country where the power cord set will be used.
2.
The power cord set must have a minimum current capacity of 10A and a nominal
voltage rating of 125 or 250 Volts AC, as required by each country's power
system.
3.
The appliance coupler must meet the mechanical configuration of an EN 60
320.IEC 320 Standard Sheet C13 connector, for mating with appliance inlet on the
Switch Box.
4.
Country-Specific Requirements
Country
Accredited Agency
United States
UL*

Related product manuals