Compaq Presario 5000 Series - Expansion Card

United States
Compaq Presario Internet PC 5000 Series Computers
Removal and Replacement Procedures
PRODUCT DESCRIPTION TROUBLESHOOTING ILLUSTRATED PARTS CATALOG
REMOVAL AND REPLACEMENT
PROCEDURES
JUMPER AND SWITCH
INFORMATION
SPECIFICATIONS
Electrostatic
Discharge
Service
Considerations
Preparation for
Disassembly
Serial Number
Side Access Panel
Graphics Card
Expansion Card
(Modem or Network
Card)
1394 Card
Memory Module
Hard Drive
Disk Drive
Removing the Top
Door
Removing the CD
Storage Door
(Lower Front Panel -
Open the CD Storage
Door)
Optical and Mass
Removing the Expansion Card
Removal
Perform the preparation
procedures.
1.
Turn the computer on its side
(open side facing up) and
locate the expansion card(s).
2.
Remove the screw securing
the expansion card.
3.
Pull the expansion card using
a gentle rocking motion from
the connector on the system
board.
4.
Replacement
Important: The
expansion card rear
connector must be
properly inserted into
the rear chassis slot to
ensure the card is
properly seated into
the connector on the
system board.
Align the card with connector
on the system board and
rear connector slots on the
1.