Compaq Presario Internet PC 5000 Series Computers
Removal & Replacement Procedures
PRODUCT DESCRIPTION TROUBLESHOOTING ILLUSTRATED PARTS CATALOG
REMOVAL AND REPLACEMENT
PROCEDURES
JUMPER AND SWITCH
INFORMATION
SPECIFICATIONS
Electrostatic
Discharge
Service
Considerations
Preparation for
Disassembly
Serial Number
Side Access Panel
Graphics Card
Expansion Card
(Modem or Network
Card)
1394 Card
Memory Module
Hard Drive
Disk Drive
Removing the Top
Door
Removing the CD
Storage Door
(Lower Front Panel -
Open the CD Storage
Door)
Optical and Mass
Service Considerations
Tool Requirements
Phillips screwdriver
1.
Needle-nose pliers2.
Flathead screwdriver3.
Compaq Utilities software4.
Screws
The screws used in these products are not interchangeable. If an incorrect screw is used
during the reassembly process, it could cause damage to the unit. Compaq strongly
recommends that all screws removed during the disassembly process be kept with the
corresponding part that was removed, then returned to their proper locations.
Important
As each subassembly is removed from the computer, it should be
placed away from the work area to prevent damage.
Cables and Connectors
Most cables used throughout the unit are ribbon cables. These must be handled carefullyto
avoid damage. Apply only the tension required to seat or unseat the cable during its
insertion or removal from the connector. Handle cables by the connector whenever
possible. In all cases, avoid bending, twisting, or tearing the cables, and ensure that they
are positioned so that they cannot be caught or snagged by parts being removed.
CAUTION
When servicing these computers, ensure that cables are placed in
their proper location during the reassembly process. Improper
cable placement can cause severe damage to the unit.
Ribbon Cable Positions Index
CD/CD-RW, and DVD Power Button
To Next Page
Loading...
