One - User Manual
Programme progression
Stimulation actually starts when the stimulation energy has been increased. The
examples reproduced below are sufficient to understand the general rules.
1 Remaining time (in minutes and seconds) before the end of the programme
2 Time bar showing contraction time and active rest time is shown only during the work sequence
3 Warm-up
4 Session sequences
5 Work period
6 Relaxation
A Press the On/Off button to interrupt the programme momentarily. To restart it, simply
press the channel + for one of the channels. The session will resume at 80 % of the
energy levels that were being used prior to the interruption.
B C D E The different energies reached during the contraction phase are shown by a
series of black bar graphs, energies of the rest phase are shown by hatched bar graphs.
N.B.: Active rest phase stimulation energies are automatically set at 50% of contraction
energies. These can be modified during the rest phase. Once modified, they will be
totally independent of the contraction energies.
End of programme
At the end of each session, the following screen is displayed and a short melody plays.
To switch off the stimulator, press the On/Off button.
A B C D E
1
253
4
6
To Next Page
Loading...
Need help?
General
