English Compex 16-Port All 10/100 Switch
DS2216
11
2b.
Press the Set button once and it will cycle to the next port. Port #1 will
light up first. Press the Set button again will jump to next port #2. Press
several times until the desired port LED lights up.
To set this port, press the Set button and hold it down for about 3
seconds until all ports LEDs flash once. When successful, this port
LED will turn OFF.
Setup complete.
100M LED Half LED Port Status
ON ON Forced to 100Mbps speed and Half-Duplex
mode
OFF ON Forced to 10Mbps speed and Half-Duplex
mode
ON OFF Forced to 100Mbps speed and Full-Duplex
mode
OFF OFF Reset to normal auto-negotiation mode
Table 1: Force Port Speed and Duplex mode
To Next Page
Loading...
