The simplest and most usual procedure is to start with level 1 and raise the level when changing to a new
stimulation cycle�
At the end of a cycle, you may either start a new cycle at the next level up or do some maintenance at the
rate of 1 session�
Power Saving: Turns the Power Saving mode function on (ON) or off (OFF)� Decreases the intensity and
the backlighting time�
Sound: Turns the Sound function on (ON) or off (OFF)�
Contraction Sound: Turns the contraction arrival warning sound on (ON) or off (OFF)�
Set Time: Allows you to set the time on the device�
Set Date: Allows you to set the date on the device�
Pair a new module: Enables a new module to be paired to the remote control�
Reset to factory settings: Enables the device to be re-set and return to the basic settings (Favorites deleted,
Objectives cleared, Default settings)�
System info: Enables information related to the device to be viewed�
To Next Page
Loading...
