RADIO FREQUENCY WIRELESS DESCRIPTION - CONTINUED
COEXISTENCE WITH OTHER COMPEX WIRELESS USA DEVICES
Compex Wireless USA wireless protocol is designed to allow coexistence with at least 3 other Compex
Wireless USA devices�
Each Compex Wireless USA remote control and module is assigned a unique ID� Before initial use, the
remote is paired with the 4 stimulation modules in its network�
Designed for coexistence with wireless products in
the same RF band�
- Bluetooth (IEEE 802�15�1)
- Wi-Fi (IEEE 802�11)
Utilizes established coexistence principles to miniize
cross-talk with other wireless devices�
- FDMA (Frequency Division Multiple Access)
- TDMA (Time Division Multiple Access)
Interference from other devices
- If all Compex Wireless USA RF channels are
saturated by emissions from other devices, the
failsafe outcome is that all stimulation modules
will stop stimulation�
- Interference from other RF wireless and mobile
communication devices is possible� Refer to
Table 4 for recommended distances between
Compex Wireless USA and other RF devices�
FCC REQUIREMENTS
This device complies with Part 15 of the FCC Rules�
Operation is subject to the following 2 conditions:
- This device may not cause harmful interference�
- This device must accept any interference
received, including the interference that may
cause undesired operation�
Remote Control FCC ID 2AD2U-REMHHTFT24
Modules FCC ID 2AD2U-NMESTNSMOD
IC REQUIREMENTS
This device complies with industry Canada’s
licence-exempt RSSs� Operation is subject to the
following 2 conditions:
- This device may not cause harmful interference�
- This device must accept any interference, in-
cluding interference that may cause undesired
operation of the device�
Remote Control IC 12752A-REMHHTFT24
Modules IC 12752A-NMESTNSMOD
To Next Page
Loading...
