Computherm E280 - 7. Basic Settings

- 21 -
thermostat you wish to assign to the installed application.
Touching the name of the thermostat concerned, it will be as-
signed to the application, and from now on the thermostat can
be controlled from anywhere. Following this, on the start scre-
en of the application all assigned thermostats appear, together
with currently measured (PV) and set (SV) temperatures.
Attention! If you want to avoid that other users can add
your COMPUTHERM E280 thermostat to their phone app-
lications, you can disable this operation as described in
Sub-chapter7.2.
7. BASIC SETTINGS
After the application has been started, COMPUTHERM E280
thermostats assigned to the application concerned appear on
page “MyThermostat’s”.
7.1.Renamingthethermostatassignedtotheapplication
Name HVAC is given to each thermostat in the factory. To mo-
dify the name, tap and hold the thermostat concerned within
the application until a pop-up window with the name of “Edit
Thermostat” appears. Here you can modify the name of the
thermostat within the application by tapping the “Modifycur-
rentthermostat” icon.