- 37 -
is located at the top of the screen for programming, beside
the legend LOOP. Touching this, you can switch between
programming modes as follows:
- 12345,67: 5+2 mode
- 123456,7: 6+1 mode
- 1234567: 7+0 mode
c) Switches belonging to a given programming mode are
below the indication of the programming mode. You can
modify data (time, temperature) of switches by tapping the
value concerned.
d) To complete programming and return to the screen belon-
ging to the thermostat touch the < icon in the upper left
corner.
Programs that were set earlier can be checked at any time
by entering the programming mode again.
• Onthethermostat:
a) To enter programming mode touch the button for ap-
proximately 5 seconds. Then on the display the legend
LOOP appears in place of the hour, and the indication
belonging to the currently selected programming mode
replaces the current day.
To Next Page
Loading...
