www.comtecltd.com For Kasco service use only.
iv
SAFETY FIRST
READ THE ENTIRE MANUAL BEFORE ATTEMPTING TO OPERATE THE PRESS.
COMTEC HAS INSPECTED THIS PRESS. OTHER THAN TRANSIT DAMAGE, NO
MODIFICATION IS NECESSARY.
THE PRESS OPERATOR MUST USE TWO HANDS (ONE ON EACH HANDLE), TO
CYCLE THE PRESS. UNDER NO CIRCUMSTANCES SHOULD A SECOND PERSON
BE INVOLVED IN LOADING OR UNLOADING THE DIE AREA OF THE PRESS.
PRECAUTION SHOULD BE TAKEN TO PREVENT A PRESS OPERATOR FROM
CIRCUMVENTING THE DUAL SAFETY HANDLES.
THE PRESS MUST BE DISCONNECTED FROM ELECTRICAL POWER BEFORE ANY
ELECTRICAL SERVICE IS ATTEMPTED. PLEASE NOTE WARNING LABEL ON TOP
COVER OF PRESS.
ELECTRICAL POWER MUST BE TURNED OFF BEFORE ATTEMPTING TO CHANGE A
DIE.
MISINSTALLATION OF A DIE MAY CAUSE MINOR DAMAGE THAT PREVENTS LOW
PRESSURE SAFETY RETRACTION FORCE FROM FULLY RETRACTING THE
HYDRAULIC RAM. DO NOT OPERATE PRESS IN THIS CONDITION. CONTACT
FACTORY FOR RECOMMENDATION.
ONLY OPERATOR OF
PRESS HANDLES IS TO LOAD
AND UNLOAD DIE AREA
To Next Page
Loading...