www.comtecltd.com For Kasco service use only.
iii
Product Description
The Model 2200 is a hydraulic machine that uses custom dies to form dough. Each size
and type of crust requires a separate, custom die. Dies that form bottom crusts are
manufactured to work with a specific pan, chosen by the customer.
To form a crust, a dough portion is placed in the center of the pan to be used. The pan is
then placed in the lower die half. USING TWO HANDS, ONE HAND ON EACH LEVER,
PRESS BOTH LEVERS to bring the lower die half up against the upper stationary heated
die half.
After a short dwell (for example, 2 seconds) the levers are released, bringing the lower die
half down. The formed crust is then removed from the die. ONLY THE OPERATOR OF
THE HANDLES IS TO LOAD THE PAN WITH DOUGH PORTION INTO, AND REMOVE
THE FINISHED CRUST FROM THE PRESS.
There are no user serviceable hydraulic components on the Model 2200. Any questions
about the hydraulic should be directed to Comtec or Comtec’s authorized representative.
The Model 2200 does not have a dedicated neutral.
with temperature control
To Next Page
Loading...