CONCEPT2.COM
Page 8
012611
Additional Notes
Setting the Level of the Dynamic Indoor Rower
The Dynamic Indoor Rower should be approximately level for the moving components to work properly.
Use the front foot leveling screws to fine tune the level as follows:
Have a friend watch you row:
• Iftheseattendstostretchthebungeemoretothefrontofthemachinethantherearwhilerowing,raise
the front of the Dynamic Indoor Rower by turning both front foot leveling screws clockwise several turns.
• Iftheseattendstostretchthebungeemoretotherearofthemachinethanthefrontwhilerowing,
lower the front of the Dynamic Indoor Rower by turning both front foot leveling screws counter-clockwise
several turns.
Handle Return Tension
The design of the Dynamic Indoor Rower has allowed us to reduce the handle return tension significantly
compared to our Model D and E. Handle return tension, inherent in erg rowing, is not something we
experience in the boat. We therefore view the lower tension that can be achieved with this design as a
positive feature. The tension is set low when we ship the Dynamic Indoor Rower and we suggest rowing
with it like this for a while before choosing to tightening the bungee if you really want it to feel “more like an
erg.” See page 16 of the User Manual for directions.
CONCEPT2 DYNAMIC INDOOR ROWER
Front Leg/
Monitor Arm Assembly
Caster Wheel
Foot Carriage
Shuttle Channel
Rail Assembly
Flywheel
Front Foot Leveling Screws