Conceptronic C150BRS4 - Advanced - Client Filters

50
5-8. Advanced - Client Filters
To benefit your further management to the computers in the LAN, you can control some ports access to Internet by
data packet filter function.
Client Filter : Check to enable client filter.
Access Policy : Select one number from the drop-down menu.
Enable : Check to enable the access policy.
Clear the Policy : Click “Clear” button to clear all settings for the policy.
Filter Mode : Click one radio button to enable or disable to access the Internet.
Policy Name : Enter a name for the access policy selected.
IP Start/End : Enter the starting/ending IP address.
Port No. : Enter the port range based over the protocol for access policy.
Protocol : Select one protocol (TCP/UDP/Both) from the drop-down menu.
Times : Select the time range of client filter.
Days : Select the day(s) to run the access policy.