18
【Video Mode】Provide PAL and NTSC both formats video formats choice, modify after you must restart your system can take effect.
【Channel】Choose to set the video Settings area passage "whole" says setting all channels
【Reserved Section】Click Settings enter. The white areas for privacy area
【Buzzer Alarm】Happen when video lost choice whether or not to allow buzzer warning
【Alarm Output】Happen when video lost upcoming linkage selected channel corresponding alarm output
(3)Motion Detection
【Channel】Choose need to set up mobile testing area passage "whole" says setting all channels
【Sensitivity Setting】Can be set to give: minimum, low, general, high, highest
【Detection Area】Click Settings enter.
Green area for dynamic test, grey areas design.ferroconcrete-brick undefended area for. Press the mouse left key to drag on the lower detection area to the right,
press the mouse button clearance. Detection area drag The save and exit button can save Settings, some give up and quit button abandon modification.
【Buzzer Alarm】Occur when dynamic test on the buzzer whether to allow the alarm
【Trigger Recording】That will happen when dynamic test on the linkage of selected channel fast ball trigger video
【Alarm Output】In this passage setting user can be copied to the other channels, fulfill the same dynamic detection alarm Settings
(4)SEQ Display
To Next Page
Loading...