Click on the icon to save the current configuration.
Chapter Seven FAQ (Frequently Asked Questions)
01：Why the DVR did not run after connect the power supply?
①Please check the power switch turn on or off at the rear panel of DVR.
②Please check if the turn on DVR operation correct or not?
③If you select the adaptor +12V, 5A or above? (8ch 5A, 16ch 220V 200W)
02：Still stop over on the boot-strap frame?
Physical damaged in hard disk drive
Boot manager abnormal.
03：Why does appear the boot running too slow?
①There are too much capacity data in hard disk drive, the system will automatic search the data when the system boot up, caused the boot
running slow.
To Next Page
Loading...