Digital Video Recorder User Manual
144
The valid value of MTU is from 500 to 1500.
If the DHCP server is available, you can check the checkbox of Enable DHCP to
automatically obtain an IP address and other network settings from that server.
If DHCP is enabled, you can check the checkbox of Enable DNS DHCP or uncheck it and edit
the Preferred DNS Server and Alternate DNS Server.
Step 4 After having configured the general settings, click the Apply button to save the settings.
11.2 Configuring Advanced Settings
11.2.1 Configuring PPPoE Settings
Purpose
The DVR also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Step 1 Enter the Network Settings interface.
Menu > Configuration > Network
Step 2 Select the PPPoE tab to enter the PPPoE Settings interface.
Figure 11-2 PPPoE Settings Interface
Step 3 Check the Enable PPPoE checkbox to enable this feature.
Step 4 Enter User Name and Password for PPPoE access.
The User Name and Password should be assigned by your ISP.
Step 5 Click the Apply button to save the settings.
Step 6 After successful settings, the system asks you to reboot the device to enable the new
settings, and the PPPoE dial-up is automatically connected after reboot.
You can go to Menu > Maintenance > System Info > Network interface to view the status of
PPPoE connection.
11.2.2 Configuring Guarding Vision (Mobile access)
Purpose
To Next Page
Loading...
