Digital Video Recorder User Manual
83
Figure 5-37 Attention Box
5.12 Configuring 1080P Lite
Purpose
When 1080p lite mode is enabled, the encoding resolution at 1080p lite (real-time) is supported. If
not, up to 1080p (non-real-time) is supported.
You can enable 1080p lite mode in two ways.
Task 1: Enabling 1080P Lite Mode in Live View
Step 1 In live view mode, connect 1080p signal to the DVR.
Then the interface as shown below will pop up to remind you to enable 1080p lite mode.
Figure 5-38 Attention
Step 2 Click Yes to reboot the device and enable 1080p lite mode.
Or click No to cancel it.
The Attention interface will only pop up in live view mode. If you enter the main menu, it
will not pop up. If you exit from the main menu and the device detects the signal, it will pop
up.
When the 1080p signal is connected to multiple channels and the interface already pops up
for one channel, the interface will not pop up for other channels.
If you click No, the interface will not pop up again if you do not disconnect it. If you
disconnect it and connect it again, the interface will pop up.
The interface will not disappear if you do not operate.
Task 2: Enabling 1080P Lite Mode in Advanced Settings
Step 1 Enter the Record menu
Menu > Record
Step 2 Click Advanced to enter the advanced interface.
To Next Page
Loading...
