Conceptronic C8XVR - Using the Mouse in Live View

Digital Video Recorder User Manual
42
 Start Auto-switch: the screen is auto switched to the next one. And you must set the dwell
time for each screen on the configuration menu before enabling the auto-switch.
Menu>Configuration>Live View>Dwell Time.
 Start Recording: normal record and motion detection record are supported.
 Output Mode: select the output mode to Standard, Bright, Gentle or Vivid.
 Playback: play back the recorded videos for current day.
 Aux/Main Monitor: the DVR checks the connection of the output interfaces to define the
main and auxiliary output interfaces. When the aux output is enabled, the main output cannot
do any operation, and you can do some basic operation on the live view mode for the Aux
output.
The VGA/HDMI output is the main output. The priority relationship is shown as Table 3-2.
Table 3-2 Priorities of Outputs
S.N
HDMI
VGA
Main output
1
√ or ×
√ or ×
VGA/HDMI
√ means the interface is in use, × means the interface is out of use or the connection is invalid. And
the HDMI and VGA can be used at the same time.
3.2.1 Using the Mouse in Live View
You can refer to Table 3-3 for the description of mouse operation in live view mode.
Table 3-3 Mouse Operation in Live View
Name
Description
Menu
Enter the main menu of the system by right clicking the
mouse.
Single Screen
Switch to the single full screen by choosing channel number
from the drop-down list.
Multi-Screen
Adjust the screen layout by selecting from the drop-down list.
Previous
Screen
Switch to the previous screen.
Next Screen
Switch to the next screen.