13
Flying
Craft/Remote Link
Before flying, the craft and the remote must be linked together and the gyroscopes on the
craft must be allowed to calibrate.
Step 2
Power the craft ON. The LED lights will
blink in unison as the craft searches for a
signal from the remote.
Step 1
Begin with the craft and remote powered
OFF and place the craft on a flat, level
surface. This is necessary for the craft’s
gyroscopes to properly align.
Step 3
Power ON the remote. The light on the
remote will blink as it searches for the
signal from the craft. An audible chime will
sound when the remote and the craft have
linked with each other.
To Next Page
Loading...