27
If you are experiencing problems using or flying the craft, consult this table.
Troubleshooting
PROBLEM POSSIBLE CAUSES SOLUTION
Craft does not
respond to controls.
• No power to remote
or craft.
• Poor contact between
power plugs.
• Craft is out of range.
• Batteries out of charge.
• Check remote batteries,
replace if needed.
• Check craft battery,
recharge if needed.
• Be sure the power plugs
are firmly connected.
• Be sure the remote has
an unobstructed line of
sight to the craft.
• Remain within the
remote’s 300 ft. range.
Craft is difficult
to control or flies
erratically.
• Gyroscopes may
be misaligned.
• Recalibrate gyroscopes
(see pg. 17).
• Power OFF remote and
craft and reconnect
(see pg. 13).
Craft drifts
while in flight.
• Trim not set or needs
adjustment.
• Adjust trim settings
(see pg. 15).
• Reset trim settings
(see pg. 17).
Craft suffers from
mechanical trouble.
• Damage to body,
rotors or other major
components.
• Repair or replace parts
as needed.
LED lights ON but
craft does not
respond to controls.
• Low battery power. • Recharge the battery.
To Next Page
Loading...