Condor DRW876 - Drone Flying: Landing and Powering Down

14
Step 5
Use the Left Control Stick to take off and
control the throttle and Yaw (spin) movement
of the craft. When you release the stick, it will
return to the neutral, middle position and the
craft should maintain its current altitude.
Use the Right Control Stick to control the
Pitch (forward/backward) and Roll (left/
right) movement of the craft.
Landing & Powering Down
To land and power OFF, pull down and hold the Left Control Stick until the rotors have
stopped spinning.
When the rotors have stopped spinning, power OFF the remote BEFORE powering OFF
the craft. This will ensure that no signals are accidentally sent by the remote, reducing the
chance of injury. After this is done, it is safe to pick up and power OFF the craft.
REMINDER:
Pulling down on the throttle does not immediately stop the rotors from spinning, you
must hold the throttle in the lowest position and wait for the rotors to stop.
To quickly stop the rotors, pull both thumbsticks down and outwards. This is regarded as
an emergency procedure and it is not recommended to perform this action while the
craft is in flight.
Step 4
Push the Left Control Stick (throttle) fully
forward, wait for a chime, then pull the stick
fully rearward and wait for a second chime.
When this last chime has sounded the
craft is ready to fly and the rotors should
automatically begin spinning.
Flying