Conlan C1000LP - Special Function Code Programming

5
Delete specic users
(4711 - default)
○ ● ○ ● ● ○ ○ ● ○ ● ○ ○
Delete all users
(4711 - default
○ ● ○ ○ ○ ●
○ ●
● ○ ○
3.3 Programmming codes for special functions
Programming the codes is described in 3.2 and 3.3. This entry activates the output(s)
for 5 seconds (factory setting). Only 1 user can enter at the time.
Programming the same user twice
Byprogrammingthesamecodeonthesamepositiontwicetogglestheoutput.
(Ie. the code is entered to unlock the door and entered to lock it again).
Programming the same user 3 times
Byprogrammingthesamecodeonthesameposition3times,theoutputisdesignat-
edasswitchononly.
(Ie. the door is permanently unlocked when the code is entered).
Programming the same user 4 times
Byprogrammingthesamecodeonthesameposition4times,theoutputisdesignat-
edasswitchoonly.
(Ie. the door is only locked when the code is entered).
#
Key in the
Master code
#
Key in the
user position
##
#
Key in the Mas-
ter code
#
Key in
2500
#