Conlan C1000LP - Advanced System Configuration; Service Code Usage for Settings; Configuration Overview and Defaults; Changing the Master Code

8
5.CongurationofC1000LP
5.1 The Service code
The Service code is used for C1000LP’s advanced settings such as changing the Master
codeandServicecode,LEDindicationsandmuchmore.Theoverviewofthesettings
and the factory settings can be seen in 4.2 Conguration overview.
The Service code is 12347890 (factory setting).
Note: Before the Service code can be used must the voltage be turned OFF and
ON (the Service code can now be entered within 10 seconds).
After entering the Service code the reader is in programming mode (the green LED
lights). Each time a setting is made the C1000LP goes back to the previous point and
the next setting can be made.
Thenavigationisbyenteringtheposition/valuefollowedby#.
5.2Congurationoverview
Position Setting Factory default
00 Master code (1 to 8 digits) 4711
01 Service code (1 to 8 digits) 12347890
02  LEDindications   Normal=Yellow,active=Yellowandgreen
03 Outputs Output time for 1 and 2 is 5 seconds
04 Special functions
05 Smart enrolling
06 Input setup
07 Time
08 Battery management
09 Locker reserve time
2500 All codes on the user positions are deleted
0250 Reset to factory default
5.3 Changing the Master code
By default the Master code is 4711 and can onlybeusedtoprogram,changeordelete
usersontheC1000LP.TochangetheMastercode,enterthefollowing:
○ ● ○ ● ● ○ ○ ● ○
Key in the
Service code
#
Key in
00
#
Keyinnewcode
#