Need help?Do you have a question about the ConMed hyfrecator 2000 and is the answer not in the manual?
Outlines critical safety warnings for shock and burn hazards during servicing operations.
Explains how DC power is converted into radio frequency (RF) output power for surgical use.
Explains the redundant microcontroller design for safety and fault detection mechanisms.
Details the normal operating mode for clinical service use and its functions.
Provides access to service functions like calibration and diagnostics.
Explains how to calibrate RF output power and HV settings for optimal performance.
Allows operation without fault detection for troubleshooting complex issues.
Details how the control and monitor microcontrollers interact for system operation.
Explains the process of detecting and responding to system faults to prevent hazards.
Details the self-test procedures performed on power-up to verify system integrity.
Outlines procedures for routine preventative maintenance checks to ensure safety.
Details tests to verify DC isolation for patient safety and electrical shock prevention.
Verifies low-frequency source current is within safety limits according to IEC 60601-1.
Details how to test the RF output power accuracy against specified limits.
Verifies RF earth-referencing and isolation to prevent patient burns.
Describes how to adjust RF output power to original factory specifications.
Guides through adjusting HI, LO, and BI modes for calibration accuracy.
Describes how to verify calibration results after adjustments using output tests.
Provides guidance on diagnosing and correcting unit problems based on symptoms.
Explains how to use fault codes generated by the unit for troubleshooting.
Provides a mode to bypass fault detection for troubleshooting complex issues.
Discusses general methods for isolating component faults within the system.
Troubleshoots issues specific to the A1 Display/Control PWB and its components.
Details how to verify microcontroller defects before replacement for cost savings.
Troubleshoots issues related to the gate waveform signals controlling the RF power amplifier.
Troubleshoots issues with the high voltage power supply, including low or high voltage.
General| Brand | ConMed |
|---|---|
| Model | hyfrecator 2000 |
| Category | Medical Equipment |
| Language | English |
To Next Page
