8
Inserting
a New N e
-~
Turn
handwheel of machine
toward
you until needle bar
reaches its highest point. Loosen
set
screw
in
needle
damp
at
bottom end
of
needle
bar
and push needle up into
bar
as far
as it will go. Long groove
in
needle must face
toward
the
left and the eye must be in line with
the
arm
of the :machine.
Tighten needle set screw securely.
To
.Commence Sewing
Turn
the balance wheel toward you with the right hand un-
til
the
needle moves down and up again to its highest point,
thus
catching
the
lower (bobbin) thread. Now pull the
end
of
the upper thread
you are holding
and
the bobbin thread will
be brought up with
it
through the needle hole
in
the
needle
plate, as shown
in (Fig. 7 ) . Place both ends of thread back
under
the
presser foot. Place
the
fabric to be sewn beneath
the presser
foot, lo\ver the foot upon it and then
start
the
machine.
To Remove
the
'Work
Raise
the
needle
bar
to
its highest point, lift the presser
ioot
and
draw
the fabric back and to
the
left. Cut
the
ends
of
the threads a few inches long from the needle.
•
Fig. 7
~
To Next Page
Loading...
