How to fix SpO2 and pulse rate not displaying on Contec Medical Equipment?
If the SpO2 and pulse rate aren't displaying normally on your Contec Medical Equipment, ensure your finger is properly positioned. If the issue persists, and you are sure the device works, your SpO2 level might be too low to be detected; try again or consider visiting a hospital for a diagnosis.
What to do if SpO2 and pulse rate are not displayed stably on Contec CMS-50f Medical Equipment?
If the SpO2 and pulse rate readings on your Contec Medical Equipment are unstable, make sure your finger is placed deeply enough inside the device and try again. Also, ensure that the patient remains still and calm during the measurement.
What to do if my Contec CMS-50f device can't be turned on?
If your Contec Medical Equipment device won't turn on, it might be due to drained batteries. Try recharging the battery. If recharging doesn't solve the issue, it could be a device malfunction, in which case you should contact the local service center.
Why does the display on my Contec CMS-50f Medical Equipment turn off suddenly?
If the display on your Contec Medical Equipment device suddenly turns off, it could be due to a device malfunction, so contact the local service center. Alternatively, the battery may be drained or almost drained, so try recharging it.
Why can't my Contec CMS-50f be used for full time after charge?
If your Contec Medical Equipment device isn't holding a charge, first ensure the battery is fully charged. If the problem continues, the battery might be broken, and you should contact the local service center.
Why won't the battery of my Contec CMS-50f fully charge?
If the battery of your Contec Medical Equipment isn't fully charging even after 10 hours, it's likely that the battery is broken. Please contact the local service center.
General| Device Type | Pulse Oximeter |
|---|---|
| Model | CMS-50F |
| Measurement Parameters | SpO2, Pulse Rate |
| Pulse Rate Measurement Range | 30-250 bpm |
| Pulse Rate Accuracy | ±2 bpm or ±2% |
| Display Type | OLED |
| Power Consumption | Less than 30mA |
| SpO2 Measurement Range | 0% - 100% |
| SpO2 Accuracy | ±2% (70%-99%) |
| Resolution | 1% for SpO2, 1 bpm for Pulse Rate |
| Battery Type | 2 x AAA batteries |
| Battery Life | Up to 30 hours |
| Data Storage | No |
| Weight | 50g (including batteries) |
| Automatic shutdown | Yes |
To Next Page
