Contec CMS-50f User Manual

7
b)
b)
b)
b)
On the measuring interface, if the alarm function is on, during the period of alarming, you can
pause it by short pressing the button, but the function will be renewed in about 60 seconds.
c)
c)
c)
c)
If you want to turn off the alarm for good, you should enter the menu for operation.
E.
E.
E.
E.
Menu
Menu
Menu
Menu
operations
operations
operations
operations
W hen the device is under the measuring interface, long press the button for about 1 second in order to
enter the menu interface shown as figure 5 ( when the display mode is upright mode, the device
cannot enter the menu interface in this situation, you nee d to short press the button again to adjust the
display mode to transverse mode so that the device can enter the menu interface). U sers can adjust the
setting through the main menu, such as backlight, alarm, clock, data transmission(with the data line),
data storage, and power off. T he specific operation methods are as the following:
Figure 5. Main Menu Interface
a)
a)
a)
a)
Backlight
Backlight
Backlight
Backlight
adjustment
adjustment
adjustment
adjustment
On the main menu interface, short press the button to move the menu choice bar to “ Brightness ” , then
you can adjust the brightness of the screen by long pressing the button.
b)
b)
b)
b)
Alarm
Alarm
Alarm
Alarm
setting
setting
setting
setting
On the main menu interface, short press the button to move the menu choice bar to “ Alarm ” , then the
device would enter the alarm setting menu which is shown as figure 6 if you long press the button.
a.
a.
a.
a.
The
The
The
The
highest/lowest
highest/lowest
highest/lowest
highest/lowest
alarm
alarm
alarm
alarm
l
l
l
l
imit
imit
imit
imit
setting
setting
setting
setting
S hort press the button to move the menu choice bar to “ Direction ” , then you can choose the
highest/lowest limit by long pressing the button.If you want to raise the alarm limit of SpO
2
or pulse
rate, you should move the “ Direction ” to “ up ” , then short press the button in order to choose the
parameter that you want to raise: T he highest limit of SpO
2
( SpO
2
ALM HI ), the lowest limit of
SpO
2
( SpO
2
ALM LO ), the highest limit of pulse rate (PR ALM HI ） , the lowest limit of puls e
rate （ PR ALM LO ） , then you can raise the data to the number that you want by long pressing t he
button. I n the same way, if you want to reduce the alarm limit of SpO
2
or pulse rate, you should move
the “ Direction ” to “ down ” , short press the button to choose the parameter that you want to reduce,

Contec CMS-50f Specifications

General

Brand	Contec
Model	CMS-50f
Category	Medical Equipment
Language	English