1
1
1
1
1 Safety
Safety
Safety
Safety
1.1
1.1
1.1
1.1 Instructions
Instructions
Instructions
Instructions for
for
for
for safe
safe
safe
safe operations
operations
operations
operations
Check the main unit and
all
accessories periodically to make sure that there is no visible
damage that may affect patient
’
s safety and monitoring performance about cables and transducers. It
is recommended that the device should be inspected once a week at least. When there is obvious
damage, stop using the device.
Necessary maintenance must be performed by qualified service engineers
ONLY.
Users are not
permitted to maintain
it
by themselves.
The oximeter cannot be used together with devices not specified
in
User
’
s Manual.Only the
accessory that appointed or recommendatory by manufacture can be used with this device.
This product is calibrated before leav ing factory.
1.2
1.2
1.2
1.2 Warning
Warning
Warning
Warning
Explosive hazard — DO NOT use the oximeter
in
environment with inflammable gas such as
some ignitable anesthetic agents.
DO NOT use the oximeter while the testee measured by MRI and CT.
The person who is allergic to rubber can not use this device.
The disposal of scrap instrument and its accessories and packings (including battery , plastic
bags, foams and paper boxes) should follow the local laws and regulations.
Please check the packing before use to make sure the device and accessories are totally
in
accordance with the packing list, or else the device may have the possibility of working abnormally.
Please choose the accessories and probe which are approved or manufactured by the
manufacturer, or else
it
may damage the device.
Please choose the battery chargers which should be ensured compliance with the requirements
of IEC 601-1 , or else
it
may damage the device.
The device can only be matched with the compatible probe.
Please don't measure this device with functional tester for the device's related information.
1.
1.
1.
1. 3
3
3
3 Attention
Attention
Attention
Attention
Keep the oximeter away from dust, vibration, corrosive substances, explosive materials, high
temperature and moisture.
If the oximeter gets wet, please stop operating it.
When
it
is carried from cold environment to warm or humid environment, please do not use
it
immediately.
DO NOT operate keys on front panel with sharp materials.
High temperature or high pressure steam disinfection of the oximeter is not permitted. Refer to
User Manual
in
the relative chapter ( 7 .1) for instructions of cleaning and disinfection.
Do not have the oximeter immerged
in
liquid. When
it
needs cleaning, please wipe its surface
with medical alcohol by soft material. Do not spray any liquid on the device directly.
When cleaning the device with water, the temperature should be lower than 60 ℃ .
As to the fingers which are too thin or too cold,
it
would probably affect the normal measure
of the patients' SpO
2
and pulse rate, please clip the thick finger such as thumb and middle finger
deeply enought into the probe.
To Next Page
Loading...
Need help?
General
